FixYourDLP.com Forums

Here are actual shots of my TV... AV1_small.jpg Component1_small.JPG My DVD player is connected to Component1 and has the problem. My VCR is connected to AV1 has the problem. The Coax (ANT 1 IN) has the problem. Interestingly, I have my AT&T Uverse box connected to Component2 & it never has the pro...

OK, thanks... My TV only exhibits the problem when plugged into Composite or Component... even the port on the side has the issue. HDMI is always fine.... Is that the same thing you saw? Similar to this: Thanks No, my TV picture's problem was a green checkerboard. The cable service is plugged direc...

jjost, I wanted to see if you have had a recurrence of your problems since you replaced your Analog board? I am planning on replacing mine, as I have the same problem you did. Hopefully you get this reply! Thanks, Barry I replaced the old analog board, but the new analog board did not resolve the p...

Dear NEhelp, To follow-up on our earlier emails, I finally received and installed the new analog board Saturday. For a newbie like me, the experience was a bit harrowing, but not all that difficult. So far, the new board has solved my TV's problems -- both SD and HD pictures are fine. Knock on wood ...

Dear NEhelp, Thanks for all of the advice. I intend to order an analog board -- BP94-02049E -- probably from Samsungparts.com. Because of my travel schedule, it might be several weeks before I can order, receive and install the board. But I'll report back to the forum when I finish the replacement. ...

NEhelp,

I took a cable box from my bedroom TV and attached it to the Samsung's HDMI input. Both the cable SD and HD pictures were fine -- no green flashing lines and no faint green flashing checkerboard. So, would you say that I have a defective analog board or digital board?

Thanks,
John

Thanks for the suggestion. Unfortunately, my TV is connected directly to the cable and uses a cablecard, so I'm not too sure that I have anything that I can connect to the HDMI/DVI input. I'll have to check the upstairs TV, which is connected to cable using a cable box. If that box has an HDMI-out, ...

Thanks for all of your help. If I may trouble you a bit more. I've been doing more reading, and I have been confusing myself a bit. How can I tell whether the board to be replaced is the analog or digital board? To be more specific: 1. The HD channels (cable and OTA) start out fine and then slowly d...

Thanks. I'll likely search for the part number referenced in the Service Manual (BP94-02084A) and see how much it costs. Then before buying it, I want to get a feel as to how difficult it will be to swap out the old board for the new. I don't want to buy the new board and then find out that the repa...

Tman, I also have an HL-R5067W for which I think I need to replace digital board. I'm a bit confused as to which part number to order. Which part number did you order, has arrived yet, and how did your installation go?

Thanks,
John

Thank you for your response. I believe that BP94-01858A, BP94-01859F and BP96-02168A are all substitutes for each other. However, when I inputted my TV model (HL-R5067W) into samsungparts.com and the key word "digital," the site also listed BP94-02084A. Would you (or anyone else) know which is corre...

I have an HL-R5067W that is experiencing the checkerboard effect and green lines on both the cable digital and OTA digital channels. This effect does not appear on the menu, although the TV will freeze on the menu. Consequently, I think this might be a problem with the digital board. Unfortunately, ...