dpyagsaq

[kstokes606]

I have replaced the Lamp and the Ballast, and can not get the lamp to light. I get a green flashing lamp status indicator, and a tone that last for about a minute, then just the flashing light for a minute, then the tone and flashing light, then the indicator turns red.
I have a service manual that I use, and I am getting 340 volts, but still no light from lamp. ASll fans have been checked, and all switches checked.
Any help?

[Crowell]

Do you hear any strange noises coming from the back of the tv? Have you cleaned the inside of the tv free of dust & mold? Also check your video board for any swollen capacitors. If there are any you either must replace them or buy a new board.

[kstokes606]

All of the inside of the TV has been cleaned, to include mirrors and glass. The only sounds I hear is a tone. Once I push the power button, it will start to sound after about 5 seconds, and remain sounding for about a minute, then it is silent for about a minute This cycles for three times, and then every thing stops, and the lamp LED is steady red.

[Crowell]

have you checked the digital video board and looked at the capacitors? Here is a video of where it is in a samsung tv to give you an idea. (1:19 min)
http://www.youtube.com/user/FixYourDLPc ... jr_9A5Xd2Q

And here are som examples of what to look for.

capa01.jpg (60.35 KiB) Viewed 6631 times

capa02.jpg (45.86 KiB) Viewed 6631 times

[kstokes606]

All boards have been checked, and no swollen capacitors found. The ballast and lamp was sent off, and checked. Both of them worked on the bench, so I am at a lost. It may be bad capacitors that are not showing any outward signs, but I do not have any way to check them on the board, and to remove all of them is a bear to say the least. The power supply has test points with the readings list next to them, and all are close them what is listed.
Is there a service manual, or something that can help with the trouble shooting. I paid for one and it is of little use. It did not show a lot of the required information, and the interconnection diagram is of little use.

[Crowell]

Have you reset the lamp timer after you replaced the lamp? Also there is a possibility it might be the thermostat. Also check that the lamp door is completely closed.

[ovadoggvo]

stokes,
Check your color wheel... Is it spinning freely?

You mentioned a "tone" what do you mean? Beeping? Buzzing? Clicking? Whirling?

Color wheel replacement guide can be found here:
http://guides.fixyourdlp.com/samsung/bp96-01579a.php

Even though the guide is for a Samsung TV, tt gives you an Idea of what you are looking for...

Basic boot sequence:
Power Supply ON --> DMD Board ON --> Check Color Wheel RPM (If OK Proceed) --> Check TV Temperature (If Below Threshold, Proceed) --> Ballast Fire Up (which then turns the lamp "on")

This is a "basic" sequence.

Let us know.

[kstokes606]

The tones are like a piezo buzzer pitch. I timed the tones and at 2 sec. the fans start up, at 9 sec. the tone starts, at 15 sec. the tone stops, at 48 sec. the tone starts, at 55 sec. the tone stops, at 1 min. 29 sec. tone starts, at 1 min 35 sec tone stops, at 1 min 48 sec. Lamp LED flashes, 2 min 41 sec. the Lamp LED turns steady red, fan stop. All of the switches are working OK because if I have it on and open a switch, the fans cut off until the switch is closed. I have not checked the DMD Thermal Sensor, or the Color Wheel/Optical Engine. What would the readings be for the Thermal Sensor?

[kstokes606]

Well I checked the Color Wheel, and look at what I found. That's right, a bad color wheel. The glass was broken, and a piece was stopping it from spinning. That is where the tone was coming from, I think. Where can you get just the color wheel?

[Crowell]

Here are some places you can shop around for the color wheel, (personal recommendation, I bought mine at:

http://www.discount-merchant.com/ ).

http://www.samsungparts.com/

Just remember to search by part number, not by model number, its normally printed on the color wheel connector cable. Good luck.

[KimfUp]

sildalis canada