qlyombhcr

Moderator: Angel

Post Reply
praisin777
Newbie
Newbie
Posts: 1
Joined: Mon Dec 28, 2009 10:59 pm

Magnavox 50ML8105D/17 shutting down

Post by praisin777 » Mon Dec 28, 2009 11:07 pm

I was recently given a Magnavox 50ML8105D/17 50" DLP TV. The previous owner said they knew the bulb was out and they thought there were other problems with the TV. I removed the bulb and its filament was shattered. A new bulb was installed. The problem now is when I power up the set the Lamp and Temp indicators turn red after only about 1 second of the bulb being on. The power LED then goes red. No matter how long the unit sets that is what happens. I am assuming there is a problem with a temp sensor. Anybody have any experience with this set? Any input would be appreciated.

User avatar
grayfox
Jedi Master
Jedi Master
Posts: 1049
Joined: Sat Jun 13, 2009 9:40 pm
Location: Sunny San Diego!
Contact:

Re: Magnavox 50ML8105D/17 shutting down

Post by grayfox » Tue Mar 09, 2010 1:30 am

Hello praisin,
The most common problem associated with Temperature cutting the power to a lamp is the Fan that actually cools the lamp, not the sensor. after making sure your lamp is properly installed try turning on your tv while listening close to the area the lamp is located, you should hear a small hum (not buzz, that would be a ballast problem) and if visible through a screen a fan will/or not, turn on! If you open the tv and remove the lamp to locate the vent passage to see where the actual fan is cooling from then you can feel for the air. these Fans are really inexpensive and easy to install.
ImageUnit Foxhound

PaulfUp
TV Wizard
TV Wizard
Posts: 457
Joined: Sat May 02, 2020 7:12 am

qlyombhcr

Post by PaulfUp » Thu Dec 29, 2022 10:44 am


Post Reply

Return to “Akai DLP Discussion”