oaxcbmso

Moderator: Angel

Post Reply
DLPFan
Newbie
Newbie
Posts: 1
Joined: Mon Mar 16, 2009 7:38 pm

Blue circle

Post by DLPFan » Mon Mar 16, 2009 7:44 pm

Hi,
I recently purchased a Phillips P22 100/120W 1.0 Bare Lamp for my Hitachi 62VS69A LCD Projection TV on 2/20/09. Saturday March 14th a circle appeared in the center of the screen. It is a 36 inch circle and color is blue. The corners of the screen area are darker.
What could be the problem?

ovadoggvo
Master Technician
Master Technician
Posts: 267
Joined: Thu Mar 12, 2009 10:32 pm

Re: Blue circle

Post by ovadoggvo » Tue Mar 17, 2009 12:39 am

DLPFan,
It seems like your LCD light engine's color prisms are starting to deteriorate due to the heat of the lamp. The lamp is not the issue as this is a common problem on these LCD Projection TVs after 4-5 years. Unfortunately the optical block is the part that needs replacing and it is expensive. I would check with Discount-Merchant.com to see if they have it in stock as they seem to sell them at around $250 to $350. This will save you lots of money!

Look at this post, it seems to have a good explanation of how an LCD Projection TV works:

http://fixyourdlp.com/forum/viewtopic.php?f=18&t=56


It's unfortunate because those particular sets have a beautiful picture that to this date can fairly compete with today's plasma and LCD sets! Good luck..

User avatar
Eddie
Moderator
Moderator
Posts: 221
Joined: Thu Mar 12, 2009 8:58 pm
Contact:

Re: Blue circle

Post by Eddie » Thu Mar 19, 2009 9:52 pm

Awesome. Seems my little drawing is getting a lot of attention!

ovadoggvo wrote:DLPFan,
It seems like your LCD light engine's color prisms are starting to deteriorate due to the heat of the lamp. The lamp is not the issue as this is a common problem on these LCD Projection TVs after 4-5 years. Unfortunately the optical block is the part that needs replacing and it is expensive. I would check with Discount-Merchant.com to see if they have it in stock as they seem to sell them at around $250 to $350. This will save you lots of money!

Look at this post, it seems to have a good explanation of how an LCD Projection TV works:

http://fixyourdlp.com/forum/viewtopic.php?f=18&t=56


It's unfortunate because those particular sets have a beautiful picture that to this date can fairly compete with today's plasma and LCD sets! Good luck..
--
Eddie

Rivers85
Contributor
Contributor
Posts: 11
Joined: Mon Aug 03, 2009 2:12 pm

Re: Blue circle

Post by Rivers85 » Tue Aug 04, 2009 5:25 pm

//Damaged LCD Color Chips

The light engine for the LCD rear projection television works with three LCD color chips (red, green and blue). Inside the light engine, the light passes through several mirrors and filters which separate the light beam into three beams of light redirecting them to pass through each one of the color chips. Then the three rays of light reach a prism which sends out picture to the screen.

Here you'll see the schematic of the LCD light engine: http://www.oerlikon.com/ecomaXL/index.p ... _projector

Through time the heat of the light beam will start to ware off the chips until they get burn marks causing colored blobs in the screen.

//LCD Color Chips
LCD Color Chips.JPG
LCD Color Chips.JPG (34.66 KiB) Viewed 4107 times
//Burned LCD Chip
Damaged Color chip.jpg
Damaged Color chip.jpg (6.67 KiB) Viewed 4107 times
//Yellow blob in the picture caused by a defective LCD color chip
Yellow Blob.jpg
Yellow Blob.jpg (44.09 KiB) Viewed 4107 times

DenfUp
TV Wizard
TV Wizard
Posts: 443
Joined: Thu Apr 23, 2020 11:58 pm

oaxcbmso

Post by DenfUp » Wed Oct 26, 2022 3:54 pm


Post Reply

Return to “Akai DLP Discussion”