ldpmqsux

Moderator: Angel

Post Reply
Harvey
Newbie
Newbie
Posts: 1
Joined: Fri Nov 27, 2009 5:56 pm

Sampo PME 50X6 need schematic(s)

Post by Harvey » Fri Nov 27, 2009 7:00 pm

My old Sampo PME 50X6 still gives a better picture than any that I have evaluated, including my new Panasonic 50PZ80U, but the PME 50X6 picture flickers, especially when the overall picture content is bright. Poking around on the boards showed some sensitivity when the PW 0500 Aux power supply board was poked and prodded, and since I have no schematic, it's punt & guess and I went ahead and ordered a new PW 0500 from "Discount-Merchant". If anyone has access to a PME 50X6 schematic set, I am interested in buying. Also if anyone has any suggestions as to the fault, I would be interested in hearing them.

Thank you!

ovadoggvo
Master Technician
Master Technician
Posts: 267
Joined: Thu Mar 12, 2009 10:32 pm

Re: Sampo PME 50X6 need schematic(s)

Post by ovadoggvo » Thu Feb 18, 2010 11:23 pm

Harvey,
What do you mean by flickering picture? I'm not understanding... Is it red dot's on the screen? Is the screen shutting off and on?

Red Dots can be caused by improper voltage going to the plasma panel by the X and/or Y Sustain boards. These boards normally have potameters to adust the voltage (Be careful doing this). As the plasma panel gets older the voltage required to operate the panel changes, also as the boards get older the modules on the board get worn out and can cause inconsistent voltage output.

I hope this helps!

AshfUp
TV Wizard
TV Wizard
Posts: 4332
Joined: Mon Apr 27, 2020 6:44 pm

ldpmqsux

Post by AshfUp » Fri Dec 23, 2022 8:25 pm


Post Reply

Return to “Akai DLP Discussion”